Tunstall ComStation BUS-C - 12 Put the Comstation BUS-C into Operation

00 8811 17, 08/18 (Rev. 6.0) 61
12. Put the ComStation
BUS-C
into operation
It's only permitted to system administrators to install and setup a new Com-
Station
BUS-C
. For this s/he needs the so-called configuration password which
can be obtained from Tunstall GmbH.
For setting up a new ComStation
BUS-C
the physical address has to be adjust-
ed. This address must match to the address set up in the „SystemOrganizer“
configuration software.
This is how you proceed:
1. Plug the ComStation
BUS-C
plug into the connection socket.
2. Tighten both screws of both plugs of the connection cable to protect the
plugs against unintentional disconnection.
 In the display appears: „Initialization“.
3. Please wait until initialization procedure is completed.
 The log-on window appears, see page 18.
4. Press „Log On“.
 You are logged on.The main window appears, see page 15.
5. Press „System“ > „Config“ > „Adjust Address“.
 You are prompted to enter the configuration password.
6. Enter the configuration password, which you obtained from Tunstall
GmbH, by pressing the select buttons corresponding to the figures.