turck TBEN-S2-2RFID-4DXP - Command: Stop Continuous (Presence Sensing) Mode

Setting
RFID channels — overview of commands
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | more@turck.com | www.turck.com
07.00 | 2022/09 | 128
8.8.9 Command: Stop Continuous (Presence Sensing) Mode
Continuous and Presence Sensing Mode can be stopped via the Stop Continuous (Presence
Sensing) Mode command. The data stored in the buffer memory of the interface is not deleted
and can still be queried by the controller via the Read buffer (Cont. Mode) command.
See description of the output data, p. [}105].
Request
Loop counter See description of the output data
Command code 0x0012 (hex.), 18 (dec.)
Read/write head address Not required
Length UID/EPC Not required
Start address Not required
Length Not required
Timeout See description of the output data
Write fragment No. 0
Read fragment No. See description of the output data
Write data Not required
See description of the input data, p. [}100].
Response
Loop counter See description of the input data
Response code 0x0012 (hex.), 18 (dec.)
Length Not required
Error code See description of the input data
Tag in
detection range
See description of the input data
Data (bytes) available See description of the input data
Tag counter See description of the input data
Write fragment No. 0
Read fragment No. See description of the input data
Read data Not required