75
NOTE: Two type teeth are available:
Standard teeth are made of AR steel.
145
Carbide teeth have a carbide tip on the end of the
tooth.
NOTE: Carbide teeth offer much longer life than
Standard teeth. Due to tooth spacing and rotor tube
material, carbide teeth cannot be welded to a
standard tooth rotor. A new rotor with carbide teeth
can be ordered through your dealer.
CAUTION: When welding teeth to the rotor the
ground cable MUST be connected directly to the
rotorto prevent currentfrom flowing throughthe
rotor bearings which will cause damage to the
bearings.
146
To Next Page
Loading...