78
END OF SEASON STORAGE SERVICE
CLEAN THE ENTIRE MACHINE AND
ENGINE
Thoroughly clean the machine and engine then blow
dry with 50 PSI compressed air.
ENGINE SERVICE
1. Refer to the engine manufactures manuals for
specific recommendations and procedures.
MACHINE SERVICE
1. Lubricate all grease point as shown in the
Lubrication Section.
2. Lubricate all linkage pivot points.
3. Spray exposed cabled with a fluid lubricant to
prevent binding and rust.
4. Lubricate chain with chain lubricant.
5. Examine all belts for damage and replace as
required.
6. Check the condition of all shields and replace as
required.
7. Check safety decals and replace as required.
8. Check all bearing and gearboxes for bearing
condition. Replace any loose bearings.
9. Check condition of the teeth on the rotor and
replace as required.
To Next Page
Loading...