Operator’s Manual 2023 Rev G p/n 2023
24
OPERATION
05
1. Inspect the blower mounting, drive line, PTO,
and air lter for damage.
2. Remove the camlock dust cap and connect the
hot air hose.
3. Follow the trailer instructions regarding product
hose connection and valve operation.
4. Slowly engage PTO with the engine at idle,
bring it up to operating speed, and lock the
engine at the recommended speed (shown in
the cab).
5. Unload the trailer as per trailer manufacturer’s
recommendation. Do not exceed the maximum
tank pressure.
6. While discharging, visually check the blower
for vibration, mechanical noise or excessive
heat.
7. If the relief valve is opening, adjust the
proportioning valve to reduce the tank
pressure.
8. Reduce pressure to zero as per the trailer
manufacturer’s instructions.
9. Disengage PTO. No cool‑down period is
required.
10. Disconnect the blower hose and replace the
camlock dust cap.
WARNING
!
The blower and accessories will
become hot enough to cause
serious skin burns on contact.
Rotating machinery is
dangerous.
Always wear ear protection
when near an operating blower.
Do not run at slower RPM to cool unit down.
Slower RPM will produce heat.
To Next Page
Loading...
