Why is my Tuttnauer 2340EKA leaking at the door?
If your Tuttnauer Laboratory Equipment is leaking at the door, ensure the door is tightened enough and the door gasket is sealing the chamber. If necessary, replace the door gasket.
Why are wraps burned after using Tuttnauer Laboratory Equipment?
To address wraps coming out burned from your Tuttnauer Laboratory Equipment, check if the water sensor is dirty. Also, verify that the wall outlet voltage is not too high and ensure items are not touching the chamber walls or bottom. Load the autoclave according to the instructions.
How to clean a very dirty Tuttnauer 2340EKA Laboratory Equipment chamber?
To clean a very dirty chamber in your Tuttnauer Laboratory Equipment, use Chamber Brite ™. Very dirty machines may require two cleanings.
Why does Tuttnauer 2340EKA take so long to heat up?
If your Tuttnauer Laboratory Equipment takes too long to heat up, clean the air jet and check for proper voltage at the wall outlet.
What to do if spore tests fail in Tuttnauer 2340EKA Laboratory Equipment?
If spore tests are failing or indicator strips are not turning in your Tuttnauer Laboratory Equipment, clean the air jet. Also, make sure the sterilization time and temperature are set correctly, and ensure the autoclave is not too heavily loaded.
Why does Tuttnauer 2340EKA printer feed paper constantly?
If the printer on your Tuttnauer Laboratory Equipment gives paper feeds all the time when the machine is switched on, make sure the ‘feed button’ on the printer is not stuck.
How to troubleshoot Tuttnauer 2340EKA machine not responding?
If your Tuttnauer Laboratory Equipment machine isn't responding, verify that the main switch is in the ‘On’ position, the power cord is properly connected to both the machine and the mains, and the circuit breaker hasn't tripped. Also, check the reset button on the cut-out thermostat.
What to do if Tuttnauer 2340EKA Laboratory Equipment process fails during heating stage with a HIGH TEMP message?
If your Tuttnauer Laboratory Equipment process fails while initiating the heating stage and displays a HIGH TEMP message, try changing the setting of the thermostat.
How to clean a very dirty chamber in my Tuttnauer 2340EKA?
If the chamber of your Tuttnauer Laboratory Equipment is very dirty, use Chamber Brite ™ to clean the autoclave; very dirty machines may require two cleanings.
What does ‘Low Heat’ mean on my Tuttnauer 2340EKA?
If the message ‘Low Heat’ is displayed during heat up on your Tuttnauer Laboratory Equipment, it indicates a bad temperature sensor. If heating elements are remaining on instead of cycling on and off, call for a technician.
Lists electrical data, including voltage, amperage, and fuse ratings.
Lists detailed chamber dimensions, volumes, and pressure ratings.
Describes the operation and functions of the control panel keys.
Lists error messages, their causes, and associated safety measures.
Details sterilization parameters and sequence for unwrapped items.
Covers electrical connection, safety, and initial unit configuration.
Outlines daily, weekly, and periodic maintenance tasks.
Covers machine response, heat, water level, and pressure issues.
Addresses issues with exhaust time, door seals, clogged strainers, and drain problems.
Solutions for failing spore tests, wet/burned wraps, instrument rusting, and drying problems.
General| Brand | Tuttnauer |
|---|---|
| Model | 2340EKA |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
