TYAN S1846 - Peripheral Setup

http://www.tyan.com
60
Chapter 4
BIOS Configuration
Peripheral Setup
Peripheral Setup options are displayed by choosing Peripheral Setup from the
AMIBIOS Setup main menu. All Peripheral Setup options are described here.
Fail-Safe Default Optimal Default
Power Interruption Disabled Disabled
OnBoard FDC Auto Auto
OnBoard Serial Port1 3F8h 3F8h
OnBoard Serial Port2 2F8h 2F8h
Serial Port2 Mode Normal Normal
**IR Duplex Mode N/A N/A
**Receiver Pin IRRX1 IRRX1
OnBoard Parallel Port 378 378
Parallel Port Mode Normal Normal
**EPP Version N/A N/A
**Parallel Port DMA Channel N/A N/A
OnBoard IDE Both Both
** Setting is not Selectable
Power Interruption
The settings are Enabled or Disabled.
Onboard FDC
Set this option to Enabled to enable the floppy drive controller on the
motherboard. The settings are Auto, Enabled, or Disabled.
Onboard Serial Port1
This option specifies the base I/O port address of serial port 1. The settings
are Auto, Disabled, 3F8h, 2F8h, 3E8h, or 2E8h.
Onboard Serial Port2
This option specifies the base I/O port address of serial port 2. The settings
are Auto, Disabled, 3F8h, 2F8h, 3E8h, or 2E8h.
Serial Port2 Mode
This option specifies the operating mode for serial port 2.This option will not
appear if the Onboard Serial Port2 option is set to Disabled, or is set to Auto
and your system does not have an onboard serial port 2. The settings are
Normal, Sharp-IR, IrDA, and Consumer. (EXPLAIN)