http://www.tyan.com
64
Chapter 4
BIOS Configuration
select the User Security option and enter a password for the user.
You can enter a new User password at any time simply by selecting the User
Security option, and typing in a new password. To enter a new Supervisor
password, select the Supervisor Security option. You will be asked to enter the
current password. After you do so, you will be prompted to enter the new
password.
In either the Supervisor or User Security options, pressing <Enter> once when
asked for a new password, and a second time when asked to confirm the new
password, will uninstall the existing password. Note that uninstalling the
Supervisor password uninstalls the User password as well.
Anti-Virus Security
If Enabled, the virus protection program helps you monitor your system for
viruses. During and after the system boot up, any attempt to write to the boot
sector or the partition table of the hard disk drive will halt the system and
produce an error message. If a warning appears, you should run an anti-virus
program to locate the problem. This feature protects only the boot sector, not
the entire drive. Note that some disk diagnostic programs will trigger a virus
warning message.
Virus Protection
Disabled
Enabled
Detect IDE Utility
You can ask the BIOS to detect all of the attached IDEs at once by selecting
the Detect IDE Utility option (you can detect IDEs individually in the Standard
Setup menu). After a second or so (during which you can cancel the detection
by clicking on the <Cancel> button with your mouse) the following dialog box
will appear:
To Next Page
Loading...
