Tyco DSC PowerSeries PC1808 - Page 49

PowerSeries - PC1616/PC1808/PC1832/PC1864
46
[377] Communication Variables
Default
004 I_______I_______I_______I Swinger Shutdown (Alarms and Rest) 001-014 Transmissions
003
I_______I_______I_______I Swinger Shutdown (Tampers and Rest) 001-014 Transmissions, 000=disabled
003
I_______I_______I_______I Swinger Shutdown (Maint and Rest) 001-014 Transmissions, 000=disabled
000
I_______I_______I_______I Communication Delay 001-255 seconds
030
I_______I_______I_______I AC Failure Communication Delay 001-255 minutes, 000=disabled
040
I_______I_______I_______I TLM Trouble Delay No. of checks required - valid entries 003 - 255)
030
I_______I_______I_______I Test Transmission Cycle (land line) 001-255 days/minutes†
030
I_______I_______I_______I For Future Use
007
I_______I_______I_______I Zone Low Battery Transmission Delay 000-255 days
030
I_______I_______I_______I Delinquency Transmission Cycle 000-255 days/hours
000
I_______I_______I_______I Communications Cancelled Window 000-255 minutes
† Dependent on programming in section [702], option [3].
[378] Test Transmission Time of Day
Default
9999 I_______I_______I_______I_______I Valid entries are 0000-2359 (9999 to disable)
[379] Periodic DLS Time of Day
Default
9999 I_______I_______I_______I_______I Valid entries are 0000-2359 (FFFF to disable)
[380] First Communicator Options
[381] Second Communicator Options
Opt Def ON OFF
1
 
Communications Enabled

Communications Disabled
2

Restorals on Bell Time-out
 
Restorals Follow Zones
3

Pulse Dialing
 
DTMF Dialing
4

Switch to Pulse Dialing on 5th Attempt
 
DTMF Dial For All Attempts
5
 
3rd Telephone Number Enabled

3rd Telephone Number Disabled
6
 
Alternate Dial (1st & 3rd)

Call 1st Number, Back up to 3rd
7

For Future Use
 
8

Delinquency Follows Zone Activity (Hours)
 
Delinquency Follows Arming (Days)
Opt Def ON OFF
1

Open After Alarm Keypad Ringback Enabled
 
Open After Alarm Keypad Ringback Disabled
2

Open After Alarm Bell Ringback Enabled
 
Open After Alarm Bell Ringback Disabled
3

SIA Sends Programmed Reporting Codes
 
SIA Sends Automatic Reporting Codes
4

Closing Confirmation Enabled
 
Closing Confirmation Disabled
5
 
Talk/Listen on Phone Lines 1/3

No Talk/Listen on Phone Lines 1/3
6
 
Talk/Listen on Phone Line 2

No Talk/Listen on Phone Line 2
7

Contact ID Uses Programmed Reporting Codes
 
Contact ID Uses Automatic Reporting Codes
8

Future Use

