Tyco T1200 - Fire Output; Fault Output

T1200
19A-4-O
3 06/09
PAGE 8 of 13
o The cursor indication will pulse the yellow
Zone 1 fault LED.
• To select the Fire Output:
Use the Select ↑ button to move the pulsed
cursor indication up through the fault LEDs
until it pulses the Fire Output Fault/Disabled
LED. [The Select ↓ button moves the cursor
down].
• To disable the Fire Output:
o Press the Disable button to disable the Fire
Output.
o The Fire Output Fault/Disabled LED will
change to the “On-flash” indication while
the cursor is on it, changing to steady if the
cursor is moved.
o The general Disablement LED will light.
• To enable the Fire Output:
o Press the Enable button to enable the Fire
Output.
o The Fire Output Fault/Disabled LED will
change to the “Off-flash” indication while
the cursor is on it, changing to off if the
cursor is moved on.
o The general Disablement LED will be
cleared if no other disablements are present.
• To quit the disable/enable mode:
o To exit the Select Mode, press the Select
On/Off button.
o The Select On LED will clear.
o The cursor indication will clear.
o Set the Access Controls Keyswitch back to
position “0” to lock the controls.
4.4 To Disable/Enable the Fault
Output.
• To Access disable/enable mode:
o Turn the Access Controls Keyswitch on the
panel door to position “1”.
o Press the Select On/Off button to enter the
Select Mode.
o The Select On LED will light.
o The cursor indication will pulse the yellow
Zone 1 fault LED.
• To select the Fault Output:
o Use the Select ↑ button to move the pulsed
cursor indication up through the fault LEDs
until it pulses the Fault Output
Fault/Disabled LED. [The Select ↓ button
moves the cursor down].
• To disable the Fault Output:
o Press the Disable button to disable the Fault
Output.
o The Fault Fault/Disabled LED will change
to the “On-flash” indication while the
cursor is on it, changing to steady if the
cursor is moved.
o The general Disablement LED will light.
• To enable the Fault Output:
o Press the Enable button to enable the Fault
Output.
o The Fault Output Fault/Disabled LED will
change to the “Off-flash” indication while
the cursor is on it, changing to off if the
cursor is moved on.
o The general Disablement LED will be
cleared if no other disablements are present.
• To quit the disable/enable mode:
o To exit the Select Mode, press the Select
On/Off button.
o The Select On LED will clear.
o The cursor indication will clear.
o Set the Access Controls Keyswitch back to
position “0” to lock the controls.
4.5 To Disable/Enable Fire Protection
Output[s].
• To Access disable/enable mode:
o Turn the Access Controls Keyswitch on the
panel door to position “1”.
o Press the Select On/Off button to enter the
Select Mode.
o The Select On LED will light.
o The cursor indication will pulse the yellow
Zone 1 fault LED.
• To select the Fire Protection Output:
Use the Select ↑ button to move the pulsed
cursor indication up through the fault LEDs
until it pulses the Fire Protection
Fault/Disabled LED. [The Select ↓ button
moves the cursor down].
• To disable the Fire Protection Output:
o Press the Disable button to disable the Fire
Protection Output.