(3) Antifreeze
If coolant freezes, the engine can be
damaged.
Clean the radiator thoroughly
before adding antifreeze.
The mixture ratio of antifreeze is
different by manufacturers and
temperature. Refer to the manu-
facturer's manual.
Mix antifreeze with water suffi-
ciently before adding it.
Adding antifreeze
If evaporated - Add water for the
reduced amount.
If leaked - Add mixture of anti-
freeze and water with the same
mixture ratio.
•
•
•
•
If engine coolant gets on your
skin, it can irritate the skin and
cause a skin condition. Make
sure to clean your skin with
soap and water or hand cleaner
thoroughly.
•
CAUTION
CLEANING RADIATOR AND
CONDENSER GRILLES
When working in a grassy field or
working at night, the radiator or
condenser grille may be clogged
by grass, straws or bugs, reducing
cooling performance.
In this case, clean the grille. If dust
is stuck between the fan and tube,
flush the area with clean water.
►
Do not clean the radiator n with
water jet. It can deform the n.
•
NOTE
T39O504A
Drain Cock
(2) Change
①
To drain coolant, open the drain
cock and radiator cap as well for
faster draining.
At this time, place the heater
cock in the opening position.
②
Wash the inside of the radiator
with clean water thoroughly.
③
Fit the drain cock and add cool-
ant.
④
Start and idle the engine for ap-
prox. 5 minutes. Then, check
coolant in the reservoir tank and
add more coolant as necessary.
T4HO506A
Condenser
grill
To Next Page
Loading...
