HOW TO START ENGINE
① Make sure that there is no ob
-
stacle around the tractor.
②
Seat on the driver's seat and
conrm that the parking brake is
applied.
③
Check that each shift lever and
PTO switch are in the neutral
position.
④
Pull the throttle lever halfway.
⑤
Depress the clutch pedal. The
safety switch is activated.
⑥
Insert the key into the main
switch and turn the switch to
the "ON" position. Check that
the engine oil lamp and charge
warning lamp come on.
⑦
Turn the main switch to the
"START" position. When the
engine is started, release the
switch.
⑧
Confirm that all monitoring lamps
go off after the engine is started.
►
1. ENGINE STARTING
The engine will not start unless
the brake pedal is depressed.
Do not turn the main switch to
the "START" position while the
engine is running.
Avoid running the start motor
over 10 seconds. It consumes a
lot of current.
If the engine cannot be started
within 10 seconds, wait for 30
seconds and try it again.
The engine cannot be started
unless the driver is seated on
the driver's seat. Start the en-
gine on the driver's seat.
•
•
•
•
•
NOTE
Never start the engine by con-
necting the start motor terminal
or safety switch directly. The
tractor may move suddenly and
cause an accident.
•
WARNING
To Next Page
Loading...
