TYM T394C - Checking and Changing Front Axle Oil

5 - 8
MAINTENANCE AND SERVICE
CHECKING AND CHANGING
FRONT AXLE OI
L
(1) Inspection
① Pull out the dipstick, wipe its tip and
insert it again. Then, pull it out and
check that the oil level is between
the upper and lower limits.
②
If insufcient, add oil.
►
(2) Changing
①
Unscrew the drain plugs on the
bottom of the axle and left/right
final cases to drain engine oil.
Since hot fluid flows out of the
engine rst, be careful not to get
burnt.
② After draining oil, tighten the oil
drain plug.
③ Add the specified amount of the
specied oil through the ller hole.
Do not add front axle oil over
the upper limit level.
Check the front axle oil before
starting the engine or at least
in 5 minutes after the engine is
stopped.
When trying to use new oil from
a different manufacturer or oil
with different viscosity, drain
used oil completely before add-
ing new oil.
•
•
•
NOTE
(3) Oil specification
Gear oil SAE 90W
(API GL-4 grade or higher)
If oil gets on your skin, it can ir-
ritate the skin and cause a skin
condition. Make sure to clean
your skin with soap and water
or hand cleaner thoroughly.
Make sure to cool down the
engine sufciently before drain-
ing oil. Oil is very hot and can
cause a burn if changing oil
right after the engine is stopped.
•
•
CAUTION
T474NCUSM1-영문-05(마).indd 8 2019-02-21 오전 8:43:22