Emission Control Label
If you install the engine in a way that makes the engine's emission control information label hard to read during
normal engine maintenance, you must place a duplicate label on the equipment, as described in 40 CFR 1068.105.
Fuel Inlet Label
Unless otherwise specified, ENGINE will also provide a supplemental fuel inlet label with each certified engine
for installation on the equipment. Permanently attach this label to the equipment near the fuel inlet.
Installation Evaluation
ENGINE CO., LTD. and its regional headquarters will determine approval of applications to the guidelines of the
Application Manual, including these Emission-Related Installation Instructions.
To ensure engine performance and exhaust emissions compliance ENGINE will review net rated output based
on engine build, intake air restriction, exhaust back pressure, engine heat balance and any other operational
characteristic required under the Engine Installation Evaluation process.
Engine Maintenance
Equipment manufacturers are responsible for relaying all emission-related service intervals to the final consumer
of the product.
For equipment manufacturers who prepare their own warranty cards, owner's manuals, service manuals,
operation manuals and any related documents; they must reference the emission-related service intervals and
procedures indicated in Y ANMAR's technical documents: Warranty Statement, Operation Manual, Service
Manual and Application Manual.
To Next Page
Loading...
