3. INSPECTING AND CHANGING COOLANT
ENGINE COOLANT INSPECTION
AND CHANGE
(1) Inspection
Open the radiator cap and check
that the radiator is filled with cool-
ant up to its filler inlet. If the coolant
amount is insufficient, add more
coolant.
►
(2) Change
① To drain coolant, open the drain
cock and radiator cap as well for
faster draining.
At this time, place the heater
cock in the opening position.
② Wash the inside of the radiator
with clean water thoroughly.
③ Fit the drain cock and add cool-
ant.
④ Start and idle the engine for ap-
prox. 5 minutes. Then, check
coolant in the reservoir tank and
add more coolant as necessary.
Do not open the cap when the
engine is hot. Otherwise, hot
steam can burn you seriously.
Wait until the engine is suffi-
ciently cooled down.
•
WARNING
(3) Antifreeze
If coolant freezes, the engine can be
damaged.
Clean the radiator thoroughly
before adding antifreeze.
The mixture ratio of antifreeze is
different by manufacturers and
temperature. Refer to the manu-
facturer's manual.
Mix antifreeze with water suffi-
ciently before adding it.
Adding antifreeze
If evaporated - Add water for the
reduced amount.
If leaked - Add mixture of anti-
freeze and water with the same
mixture ratio.
•
•
•
•
T4HO505A
Inlet
Radiator
Check hoses
T39O504A
Drain cock
To Next Page
Loading...
