(1) When driving the tractor to at-
tach or detach an implement,
make sure that there is no one
in between or around the tractor
and implement.
(2) Install and remove the imple-
ment only on safe and level
ground.
(3) When installing a heavy imple-
ment, install weight on the front
to keep balance.
(4) When adjusting an implement,
apply the parking brake, stop the
engine and set the PTO switch
in the OFF position in advance.
(5) To tow anything, use the towing
hitch only.
ROTAVATOR
<Safety precautions for rotavator>
Never remove the safety cover
of the rotavator.
Do not remove the PTO shaft
cover and safety cover on the
universal joint.
When adjusting each part, disen-
gage the PTO and stop the en-
gine in advance.
When driving on a road, keep
the PTO disengaged. Also, keep
the rotavator lowered on a road
as long as it does not hit the
ground.
For the universal joint, its inner
shaft and outer shaft should be
overlapped at least 15 cm.
Check that the universal joint is
rmly xed to the tractor and ro-
tavator shaft.
►
•
•
•
•
•
•
1. PRECAUTIONS FOR HANDLING IMPLEMENT
2. GENERAL IMPLEMENT
Read instructions on warning de-
cals on each implement thorough-
ly before work.
To avoid an injury due to mishan-
dling of an implement, read the
user's manual of the implement
thoroughly and work safely and
precisely with caution.
Installation of an improper imple-
ment can lead to an injury. Install
only implements specified by the
Manufacturer.
•
•
•
WARNING
To Next Page
Loading...
Need help?
General
