7. tractor
Manage PTO
- Stop PTO before stopping the engine.
- Do not remove the PTO protective cover or protec-
tive panel for operating machine.
- Do not use PTO adaptor in order to extend the POT
coupler or universal joint to outside of PTO protec-
tive cover.
To repair, secure the wheel width, or changing the
wheel under either tractor or trailer, with the tractor or
trailer raised, choke the wheels that are on the ground.
Do not use hydraulic jack for operating machine or
tractor. Instead, use block or stand.
Safety frame
- Do neither weld nor drill a hole on the attached safe-
ty frame. Also do not modify it.
- Replace the damaged safety frame with a new one.
- If the safety frame was removed for specialized
work, restore it immediately.
Be careful to touch dangerous area such as power
transmission gear, rotating unit, etc. Put on a protec-
tive cover.
Do neither modify nor remove the safety device.
When checking and replacing the blade to plow the
ground.
- Stop the engine.
- Prevent the rotary from falling by turning the fall ad-
justing handle to stop hydraulic pressure.
- Apply the parking brake.
- Do not stand between tractor and rotary.
When working with rotary
- Do not put your hands near the rotating part such as
blade axle and universal joint.
- Do not ride on the rotary.
-
When driving backward or turning quickly with the rota-
ry raised up, make sure to check behind the machine.
- Adjust the rear cover.
To Next Page
Loading...
