TYPHOON Q500 4K - Aircraft Preparation and Setup

Preparing The CGO3
WARNING: Before installing the flight baery and powering on the
TYPHOON you MUST remove the cover/lock from the rear of the CGO3
by carefully sliding it backward. Failure to remove the cover/lock can result
in damage to the TYPHOON and the CGO3!
QUICK TIP: It’s a good idea to re-install the cover/lock aer each flying
session and while transporng/storing the TYPHOON (just remember to
remove the cover/lock before powering on the TYPHOON and CGO3!).
Step 1) Remove the cover/lock from the rear of the CGO3 by carefully
sliding it backward.
Step 2) Slide the microSD card into the corresponding slot on the boom of
the CGO3. You can use the included 16GB card or any name brand Class 10
microSD card up to 128GB.
Step 3) Carefully remove the protecve material from the camera lens.
Installing The Propellers
WARNING: We recommend wearing gloves and using extreme care when
installing the propellers/rotor blades.
Each motor and propeller are marked with an ‘A’ or ‘B’ to ensure easy
installaon in the correct posions (for example: install propellers marked
with ‘A’ on motors marked with ‘A’).
IMPORTANT NOTE: It is NOT possible to install a propeller marked with
‘A’ on a motor marked with ‘B’. The threads go in different direcons for
the ‘A’ and ‘B’ motors/propellers.
Step 1) Use the special tool (included) to hold the motor so it cannot spin.
CAUTION: Do not over-ghten the propellers when using the tool.
Step 2) Install the corresponding propeller by rotang it trialing edge first
unl it‘s secure against the o-ring located at the boom of the motor sha.
You may want to add this: Connue to screw down the propeller 1-1.5
turns more to ensure it is properly ghten and compressing the O-rings
slightly.
Step 3) Repeat steps 1 and 2 to install the three remaining propellers
securely.
9
B
B
A
A