C099-F9P - User guide
UBX-18063024 - R16 Firmware update Page 35 of 43
C1-Public
Select the file and click Open. It will download the file and write it to flash.
☞ The ODIN-W2 UART will now be set to 460800 baud in Data default mode. It will be ready for use
again.
Disconnect s-center from the ODIN-W2 port and power the C099-F9P off and on to ensure it will be
using the new configurations as default.
Position a jumper at “OE3” for Bluetooth operation.
The rover is now ready to connect to PC or Mobile via Bluetooth SPP.
The board is now ready to use for the wireless connection examples described in the earlier sections.
When untethered operation is not required, the ZED-F9P dedicated USB connection on the C099-F9P
can be used for supplying corrections and monitoring or logging purposes with u-center.
To Next Page
Loading...
Need help?
General
