Chapter 2: Installation and Configuration
11
To access the PowerDAQ control panel, select START >
Settings > Control Panel and the PowerDAQ icon will be
displayed.
Figure 1: PowerDAQ Control Panel Application
An alternative test is to use the SimpleTest program installed
by the Software Suite. Attached a oscilloscope of multimeter
to the outputs of the AO board. Run the SimpleTest.exe
program by selecting START > Programs > PowerDAQ >
Delphi Acquisition Demo. This program shows all
information about the board(s) installed and allows you to
test all subsystems available on the board selected for the
test.
To Next Page
Loading...
Need help?
General