129
1.6.9 Logic
【wait ()】
● Wait for the next command to be sent, with the unit of seconds.
【if (Condition 1) Run (Command 1)】
● If Condition 1 is true, then Command 1 will be run. Otherwise, it will be skipped.
The setting method of the if/else sentence:
1. Click the setting button on the command block , then the command
block will pop up a selection box, as shown below:
2. At this point, drag the [else] code block to the bottom of the [if] code block, and
combine the two code blocks, as shown below:
To Next Page
Loading...
