UFactory xArm 7 User Manual

27
Mechanical dimensions of end-effector flange (unit: mm)
Drawing of tool I/O
1. Make sure the tool is properly and safely bolted in place.
2. If the end-effector does not have a locating hole, the
orientation of the end-effector must be archived as a file.
3. Make sure that the tool is safely constructed such that it
cannot create a hazardous situation by dropping a part
unexpectedly.
4. Pay attention to the operation specifications of sharp end-

UFactory xArm 7 Specifications

General

Brand	UFactory
Model	xArm 7
Category	Robotics
Language	English