Ultimaker ORIGINAL+ - Page 5

4
6.4.2. Step 2: Assembling the Heated bed PCB 60
6.4.3. Step 3: Connecting the PCB to the Baseplate 62
ćċąċąċ 0!,ąčü*%/$%*#0$!/0#!//!)(5 ćą
ćċąċĆċ 0!,Ćč%*/0((%*#0$!/0#!%*0$!)$%*! ćĈ
6.4.7. Step 7: greas it up 69
ćċĆ Ƶ//!)(%*#0$!)0!.%("!! !. ĈĀ
6.5.1. Step 1: drive mechanism main body assembly 71
6.5.2. Step 2: drive bolt assembly 73
6.5.3. Step 3: clamp assembly 75
6.5.4. Step 4: attaching the feeder to the machine 80
ćċĆċĆċ 0!,Ćč//!)(!0$!ü()!*0$+( !. ĉĀ
ćċć +1*0%*#0$!!(!0.+*%/%.1%0+.  ĉă
6.6.1. Step 1: mounting the electronic circuit board 84
6.6.2. Step 2: connecting the heater and Heated Bed 85
6.6.3. Step 3: connecting the print head electronics 87
6.6.4. Step 4: connecting the limit switches 87
6.6.5. Step 5: connecting the motors 87
6.6.6. Step 6: mounting the electronics cover 89
6.6.7. Step 7: strain relief 89
ćċćċĉċ 0!,ĉčƵ(%#*%*#0$!ġ/0#! ĊĀ
ćċćċĊċ 0!,Ċč$!'%*#* (%#*%*#0$!0+,ġ(%)%0/3%0$ ĊĀ
ćċĈ Ƶ//!)(%*#* +**!0%*#0$!(0%ƫ+*0.+((!. ĊĂ
6.7.1. Step 1: assembling the UltiController 93
6.7.2. Step 2: connecting the controller 95
7 Usage of the Ultimaker Original+ 96
Ĉċā /%*#0$!(0%)'!..%#%*(Ő"+.0$!ü./00%)! Ċć
7.1.1. Slicer software 97