Ultimaker S7 - General; Conditions

EN UltiMaker S7 Installation and user manual 36
7.1 General
UltiMaker grants a standard warranty on the UltiMaker S7 (“Product”) in the country where the
Product was purchased.
FromthedatetheProductissoldanddeliveredtoanend-customerforthersttime,asevidencedbythe
original customer’s purchase invoice, UltiMaker warrants the Product is free from defects in material, design, and
workmanship for a period of twelve (12) months. Only the original purchaser is entitled to claim warranty and the
warranty period is limited to their lifetime.
Forawarrantyclaimtobevalid(i)noticationmustbemadebeforetheendofthewarrantyperiod,(ii)conform
toanyadditionalstipulationsofthewarranty,asdenedbelow,(iii)mustbesubstantiatedwiththeoriginal
customer’s purchase invoice, (iv) the serial number sticker must still be on the Product(s), and (v) the Product
must be returned in the original packaging. Since customers will only be entitled to make a warranty claim on
submissionoftheoriginalinvoiceandpackaging,weadvisethatboththeinvoiceandocialpackagingarekept
safe. If the original packaging is not available anymore, the customer can purchase replacement packaging from a
recognized UltiMaker reseller.
The customer – provided that they are a natural person who is not acting in the course of their profession or
business – may claim the rights to which they are entitled under the warranty without prejudice to their rights or
claims in accordance with the law.
7.2 Conditions
The UltiMaker warranty is granted under the explicit condition that:
• The Product was sold, delivered, and assembled by a recognized UltiMaker reseller (see ultimaker.com/resellers
for addresses of the recognized UltiMaker resellers).
• The Product was newly manufactured on the date of purchase and not sold as used, refurbished, or
manufacturing seconds.
• UltiMaker’s latest software was installed and used in and with the Product.
• The UltiMaker’s installation and maintenance instructions as described in the manual for the Product have
been observed. Unless the manual contains ‘do-it-yourself’ assembly instructions for the Product or part
thereof and these have been followed up meticulously, the warranty will become invalidated if the Product was
at any time disassembled or reassembled by any other person than a recognized UltiMaker reseller.
Customers are welcome and we encourage them to use third-party materials, accessories, etc. That, in itself, does
not void the warranty. If, however, the use of third-party elements, causes damage to the Product, the part(s)
aectedbythisdamageisexcludedfromwarranty.
If a part of the Product is repaired or replaced during the warranty period, the warranty period still remaining for
the entire Product will apply to this part. However, repair and/or replacement will not extend the warranty period.