Need help?Do you have a question about the Ultimaker S7 and is the answer not in the manual?
General| Build Volume | 330 x 240 x 300 mm |
|---|---|
| Layer Resolution | 20 - 600 microns |
| Print Technology | Fused Filament Fabrication (FFF) |
| Max Nozzle Temperature | 280 °C |
| Max Build Plate Temperature | 110 °C |
| Print Speed | Up to 24 mm³/s |
| Filament Diameter | 2.85 mm |
| Connectivity | Wi-Fi, Ethernet, USB |
| Operating Temperature | 15 - 32 °C |
| Maximum Power Consumption | 500 W |
| Nozzle Diameter | 0.25, 0.4, 0.6, 0.8 mm |
| Print Head | Dual extrusion |
| Build Plate | Flexible, heated build plate |
| Supported Materials | PLA, ABS, Nylon, CPE, PC, TPU, PVA |
| Operating System | Linux-based |
| Power Requirements | 100-240 VAC, 50-60 Hz |
| Dimensions | 495 x 585 x 780 mm |
To Next Page