15
2-6-6. Selecting the ARCDELAY mode
This section lists the signals to perform ARCDELAY ON/OFF selection via the AD I/F connector.
ARCDELAY mode can be enabled by setting six pins of an AD I/F connector as Low.
Table 2-10 ARCDELAY mode selection input
●About ARCDELAY mode
This product has the Low ARC ENERGY circuit as output part.
Usually, ARC ENERGY is small specification in order to perform separation with a load
side quickly, when ARC (unusual electric discharge) is detected.
By enabling this function, the time to a separation start with a load side is delayable 5 us.
You can use to set up ARC ENERGY greatly intentionally.
To Next Page
Loading...