UNI-T UT8805E

UT8805E Benchtop Digital Multimeter
29
Menu
Description
I/O
The interfaces setting
System
System information and setting
Time
System time setting
Upgrade
Firmware upgrade
Default
Setting
Default settings restorable for all of the configurable items,
such as function, reading rate, input impedance, relative
value, threshold, beeper, probe type, temperature unit,
display mode, etc., see the menu for details
2.5.1 I/O Configuration
Press [I/O] to set the interfaces parameters as Figure 2-32.
Figure 2-32 Interface I/O setting
 LAN Setting
Remote operation is allowed through LAN interface. Users can check or set the current IP address, subnet
mask and gateway in network setting.
After opening the operation menu of auxiliary system function setting, press [I/O] to open the network and
select [LAN] to enter the following interface as Figure 2-33, and change the setting by direction buttons.
。
Figure 2-33 Interface of LAN setting
LAN parameters setting
Functions menu
Description
DHCP
Dynamic host configuration protocol, which can be turned on/off
IP address
IP address setting
Subnet mask
Subnet mask setting
Gate
Gateway setting
Apply
Apply current setting and return to previous menu
Return
Do not save modification and return to previous menu