By changing the acquisition setup, you can observe
the consequent changes in waveform display. If the
signal contains considerable noise, you will see the
following displays when average sampling is not
selected and when 32-time average sampling is
selected. For sampling waveform display please see
Figure 2-20 and Figure 2-21.
Set to average sampling with display of the average number of
Set the average number of times in multiples of 2, i.e. 2, 4, 8, 16,
32, 64, 128, 256. To change the average number of times, use
the control knob shown on the left in
Turn the equivalent sampling mode on or off. In this mode, selecting
alternate trigger (e.g. CH1 and CH2) as the trigger source is
To Next Page
Loading...
Need help?
General
