UNI-T UTD4000 Series

77
UTD4000 Four-channel
User Manual
Auto Setup :
AUTO
As shown above, Auto Setup can simplify operation.
Press [ ] and the oscilloscope can automatically
adjust the vertical graticule factor and horizontal time
base range according to the amplitude and frequency
of the waveform, and ensure stable display of the
waveform. When the oscilloscope is in auto setup
mode, the system setup is as follows :
Function Menu
Setup
Acquire
Normal
Horizontal position
Display format
YT
Automatically adjusted
SEC/DIV
Adjust according to signal frequency
Trigger coupling
DC
Holdoff
Minimum value
Trigger level
Set at 50%
Trigger mode
Auto
Trigger source
Automatically adjusted. See notes to Table 2-30 for details
Trigger slope
Rising
Trigger type
Edge
BW Limit
Full
VOLT/DIV
Adjust according to amplitude of the signal
Table 2- Auto setup
36