UNI-T UTD4000 Series

Item Page
Automatic Measurement
UsingtheRun/Stop
Auto Setup
Help System
Chapter3 PracticalExampleIllustrations
Illustration 1 : Measuring simple signals
Illustration 2 : Observing the delay caused by a
sine wave signal passes through the circuit
Illustration 3 : Acquiring single signals
Illustration 4 : Reducing random noise of signals
Illustration 5 : Using the cursors for measurement
Illustration 6 : Using the X-Y function
Illustration 7 :
Illustration 8 :
----------------------------------------------------------------
-----------------------------------------------------------
-----------------------------------------------------------------
-----------------------------------------------------------------------
-------------------------------------------------------------------------------
-------------------------------------------------------------
-----------------------------------------------------------------------------
------------------------
-----------------------------------
-------------------------------------------
---------------------------------------
---------------------------------------------
---------------------------------
-------------------------------
-----------------------------------------------
-----------------------------------------------
------------------------------
-------------------------------------------------
Utility Function Setup
Cursor Measurement
Multimeter Measurement
Vedio signal triggering
Using the dual time base function
Illustration 9 : Using the multimeter
64
70
74
76
77
78
78
80
80
81
83
84
86
90
92
94
95
UTD4000 Four-channel
User Manual