6. Press the control knob to
select cursor 2 then turn the
control knob again to set cursor 2 at the
center point of the second rising edge
7. Press [ ]. Current position is 100%. Set the
current value between cursor 1 and cursor
8. Press [ ], then [ ] to set the cursor at
the CH2 signal being tested. Keep cursor 1
stationary and move cursor 2.
9. Use the control knob to set
cursor 2 at the center point of the first rising edge
of the CH2 signal. This value is the phase
difference between the two signals
Figure 3-8 Using the cursors to test the
phase difference between two
To Next Page
Loading...
