UniCarriers FRSB14-8 - Page 53

INSTRUMENTS AND CONTROLSINSTRUMENTS AND CONTROLS
2-92-9
ERROR SCREENERROR SCREEN
ERROR CODESERROR CODES
If a failure occurs with the truck, the “wrench” iconIf a failure occurs with the truck, the “wrench” icon
appears along with a 3-digit error code. If an error codeappears along with a 3-digit error code. If an error code
appears, consult your appears, consult your local UniCarriers dealer.local UniCarriers dealer.
CONTROLLER OVERHEAT WARNING LIGHTCONTROLLER OVERHEAT WARNING LIGHT
The controller overheat icon blinks when the travelingThe controller overheat icon blinks when the traveling
or load handling operation is too much to the truck, withor load handling operation is too much to the truck, with
the corresponding error code “203” indicated. It usuallythe corresponding error code “203” indicated. It usually
stays off. If the icon starts blinking, stop the operationstays off. If the icon starts blinking, stop the operation
immediately and wait until the light goes out.immediately and wait until the light goes out.
MOTOR OVERHEAT WARNING LIGHTMOTOR OVERHEAT WARNING LIGHT
The motor overheat icon blinks when the drive motorThe motor overheat icon blinks when the drive motor
has overheated, with the corresponding error code “206”has overheated, with the corresponding error code “206”
indicated.indicated.
It usually stays off. If the icon starts blinking, stop theIt usually stays off. If the icon starts blinking, stop the
operation immediately and wait until the light goes out.operation immediately and wait until the light goes out.
NOTENOTE
If neglect of such warning lights will cause the truckIf neglect of such warning lights will cause the truck
to stop to stop eventuallyeventually..

https://www.forkliftpdfmanuals.com/