INSTRUMENTS AND CONTROLSINSTRUMENTS AND CONTROLS
2-162-16
ACCELERATOR PEDAL [1]ACCELERATOR PEDAL [1]
You can move the truck by pressing the acceleratorYou can move the truck by pressing the accelerator
pedal while the direction shift switch is in forward orpedal while the direction shift switch is in forward or
reverse, and the foot switch [3] is depressed.reverse, and the foot switch [3] is depressed.
The traveling speed can be controlled smoothly byThe traveling speed can be controlled smoothly by
varying the amount of pressure on the acceleratorvarying the amount of pressure on the accelerator
pedal. The traveling speed is displayed as a directpedal. The traveling speed is displayed as a direct
numeric readout on the instrument panel.numeric readout on the instrument panel.
BRAKE PEDAL [2]BRAKE PEDAL [2]
WARNINGWARNING
Avoid hard braking. You might be thrown out ofAvoid hard braking. You might be thrown out of
the truck by the sudden stop or the load the truck by the sudden stop or the load might fallmight fall
off the forks. Abusing the brakes by hard brakingoff the forks. Abusing the brakes by hard braking
will cause shorten the life of the electromagneticwill cause shorten the life of the electromagnetic
brake system.brake system.
The brake is applied by depressing the brake pedal. TheThe brake is applied by depressing the brake pedal. The
braking force can be controlled by varying the amount ofbraking force can be controlled by varying the amount of
pressure on the brake pedal. When the brake pedal ispressure on the brake pedal. When the brake pedal is
pressed down all the pressed down all the wayway, the maximum braking force , the maximum braking force isis
applied and also the drive power circuit is disconnected.applied and also the drive power circuit is disconnected.
The brake pedal is only operable when the key switch isThe brake pedal is only operable when the key switch is
in the ON position.in the ON position.
REGENERAREGENERATIVE BRAKING TIVE BRAKING (ELECTRONIC BRAKING)(ELECTRONIC BRAKING)
Regenerative braking is put into effect wheneverRegenerative braking is put into effect whenever
you reverse the direction shift switch or release theyou reverse the direction shift switch or release the
accelerator pedal.accelerator pedal.
When the accelerator pedal is releasedWhen the accelerator pedal is released
Regenerative braking (electronic braking) is in effectRegenerative braking (electronic braking) is in effect
when the accelerator pedal is released while the reachwhen the accelerator pedal is released while the reach
truck is traveling.truck is traveling.
During switchback operationsDuring switchback operations
Regenerative braking (electronic braking) occurs duringRegenerative braking (electronic braking) occurs during
switchback operations or when the direction shiftswitchback operations or when the direction shift
switch is reversed. This braking force can be adjustedswitch is reversed. This braking force can be adjusted
by varying the amount of pressure on the acceleratorby varying the amount of pressure on the accelerator
pedal.pedal.
33
22
11
To Next Page
Loading...
