UniCarriers FRSB14-8 - Page 71

INSTRUMENTS AND CONTROLSINSTRUMENTS AND CONTROLS
2-272-27
•• Do not Do not use the laser use the laser unit in a unit in a place where it place where it willwill
be subject to water splashes or condensationbe subject to water splashes or condensation
will occur.will occur.
•• Do not use tDo not use the laser unit in a place whhe laser unit in a place where theere the
laser beam might cause equipment around it tolaser beam might cause equipment around it to
malfunction.malfunction.
••
 The fork The fork positiopositio ning laser unit ning laser unit is intendedis intended
to improve work efficiency, especially whento improve work efficiency, especially when
retrieving loads from an elevated position. Theretrieving loads from an elevated position. The
operator is required to check the fork positionoperator is required to check the fork position
by direct observation as well as by looking atby direct observation as well as by looking at
the instrument panel.the instrument panel.
•• The fork positioning laser uThe fork positioning laser unit should only benit should only be
used while the truck is on a flat surface. Theused while the truck is on a flat surface. The
fork position cannot be correctly monitored onfork position cannot be correctly monitored on
an inclined surface.an inclined surface.
INSTINSTALLING THE FORK POSITIONING ALLING THE FORK POSITIONING LASER UNITLASER UNIT
••
 Install the laser unit [2] so that the laser beam sourceInstall the laser unit [2] so that the laser beam source
is 30 mm above the surface of the forks [3].is 30 mm above the surface of the forks [3].
••Adjust Adjust the the limit limit switch switch [1] [1] so so that that the the laser laser beam beam isis
only emitted when the forks are level.only emitted when the forks are level.
CAUTIONCAUTION
The installation and adjustment of the laser unitThe installation and adjustment of the laser unit
requires a high level of skill. Leave it to your localrequires a high level of skill. Leave it to your local
UniCarriers dealer.UniCarriers dealer.
20 – 42°20 – 42°
AA
11
Laser beam widthLaser beam width
Max. A:BMax. A:B ≒≒1:0.81:0.8
Min. A:BMin. A:B
≒≒
1:0.351:0.35
C C = = The beam is less than 2 mThe beam is less than 2 mm wide at a distancem wide at a distance
of 5 m or lessof 5 m or less
A: Distance A: Distance B: Beam length B: Beam length C: Beam widthC: Beam width
30 mm30 mm
22
33
1. 1. Limit Limit switchswitch
2. 2. Laser Laser markermarker
3. Fork3. Fork
(Detail of area “A”)(Detail of area “A”)

https://www.forkliftpdfmanuals.com/