unicraft PG-E Series - Description of the Device

Description of the device
PG-E-Series | Version 2.15 11
Step 1: Remove all gasoline from the fuel tank. Start and
run ethe motor until motor stops from lack of fuel.
Step 2: While motor is still warm, drain oil from crank-
case. Refill with recommended grade.
Fig. 3: Drain oil and petrol
Step 3: Remove spark plugs and pour about 1/2 ounce
(15 ml) of motor oil the cylinders. Cover spark
plug hole with rag. Pull the recoil starter a couple
times to lubricate the piston rings and cylinder
bore.
Step 4: Install and tighten spark plugs. Do not connect
spark plug wires.
Step 5: Clean the generator outer surfaces. Check that
cooling air slots and openings on generator are
open and unobstructed.
Step 6: Store the unit in clean, dry place.
6 Description of the device
Illustrations in these operating instructions may de-
viate from the original.
Fig. 4: Generator
1 Fuel tank cap
2 400 V supply connection (Model PG-E 80 TEA H)
3 Petrol tap
4 Battery
5 Oil fill cap/Dipstick
6 Tank indicator
7 Petrol tank
8 Choke
9 Spark plug
10 Silencer
11 Starter
12 Air filter
13 Ground terminal
14 ON/OFF switch; Motor START switch
Drain screw
1
2
3
4
5
6
8
9
10
11
12
13
14
7