12
Programming Scanner Frequencies
Before you can use your UBC248CLT scanner, you must program the channels. Follow these
steps:
Example: Program 420.0150 MHz into Channel 12.
Press scanner button to switch to scan mode.
1. Press MANUAL to stop scanning.
2. To select the channel (12),
press 1, then 2 on the
numeric keypad. Then press
MANUAL again.
OR
Press
▼or ▲ until channel
12 appears in the display.
3. Type in the frequency numbers, including the
decimal point, using the numeric keypad:
420.0150. Channel digits flash as you make entry.
To Next Page
Loading...
Need help?
General