Selecting a Channel
Press / to select the desired channel.
Channel Banks - Using the POLICE Button
(Only for UH9080)
The UH9080 has three banks (groups) of
channels to select from;
CB 8+)&%8VHUSURJUDPPDEOH5;FKDQQHOVï
POL Pre-programmed Police frequencies²
FIRE 3UHSURJUDPPHG)LUH$PEXODQFHIUHTXHQFLHVð
When the CB icon is showing the 80 UHF-CB and any
user programmed RX channels will be available for
selection or scanning. The 80 UHF-CB channels are
numbered 01-80. The user programmable RX channels are numbered 81-180 and only
show, in the DCS/CTCSS code area, when programmed.
When the POL icon is showing then pre-programmed police frequencies will be
available. When the FIRELFRQLVVKRZLQJWKHQSUHSURJUDPPHG¿UHDPEXODQFH
IUHTXHQFLHVZLOOEHDYDLODEOH7KHSROLFH¿UHDPEXODQFHIUHTXHQFLHVGRQRWKDYH
channel numbers, instead PO appears in the channel display for a police frequency
and FIDSSHDUVIRUD¿UHRUDPEXODQFHIUHTXHQF\
1. Press and hold [POLICE] to select the desired channel bank(s) combination.
The channel banks can be selected as follows;
---- CB ----
POL ---- ----
---- ---- FIRE
POL ---- FIRE
POL CB ----
---- CB FIRE
POL CB FIRE
NOTE
ï$YDLODEOHIUHTXHQFLHVFKDQQHOVDUHZLWKLQ0+]%DQGRQO\
in 12.5kHz steps.
ð3ROLFH)LUH$PEXODQFHUHFHSWLRQLVXQHQFU\SWHGDQDORJXH
For your reference a list of the available channels, corresponding
frequencies and guidelines for their use is printed on p.51 - p.53. For
Australia, Channels 05 and 35 are reserved for Emergency Calls.
Operation
18
UNIDEN UH9060/UH9080 UHF CB Transceiver
To Next Page
Loading...
Need help?
General
