Uniden UH9080 User Manual

3. Press [MENU] one more time.
4. Press
/ to select the desired Subcode (CTCSS or DCS).
NOTE
If a button is not pressed within 10 seconds the UHF CB Radio will
automatically exit the Menu Mode.
5. Press and hold the [MENU] to save and exit from the Menu Mode.
Open Scan (OS) Mode
$OO8+)&%XVHUSURJUDPPHGH[WUD5;FKDQQHOV3ROLFHDQG)LUH$PEXODQFH
frequencies have been added to the OS SCAN Memory for convenience. To add/remove
channels from OS SCAN Memory, refer to p.23.
Allows continuous scanning of all selected channels. If an active channel
is found, scanning will stop on that channel. If the received signal ceases, the unit will
wait 3 seconds for the signal to return, otherwise scanning resumes.
After transmission in scan mode, the unit will wait 20 seconds for the signal to return,
otherwise scanning resumes.
To select OS Scan Mode:
1. Press [MENU] six times.
7KH6&$1VHWWLQJÀDVKHV
2. Press
/ to change the setting to OS.
3. Press and hold [MENU] to save and exit from the Menu mode.
25
UNIDEN UH9060/UH9080 UHF CB Transceiver
Operation

Uniden UH9080 Specifications

General

Brand	Uniden
Model	UH9080
Category	Transceiver
Language	English