41
UNIDEN UH9060/UH9080 UHF CB Transceiver
Operation - Special Features
To Activate/Deactivate Tone Squelch (TSQ) on a
Channel
1. Use / to select the channel you want to put in or take out of ‘QUIET’ mode.
2. Press [TSQ]. Beep will sound and the TSQ icon appears on or disappears from
the LCD display.
Receiving a Selcall
While in TSQ mode, when UH9060/UH9080 receives a code matching your Selcall ID, it
will perform the following operations:
a) Automatically responds to the caller by transmitting Acknowledge Tones.
b) Informs you that a caller is on the Channel by emitting a CALL ALARM
(Default Alarm Setting: four successive beeps in a regular interval for 10 seconds.
Refer to p.46, ‘Alarm Mode’ for other alarm settings) and displays the CAL icon.
c) Flashes the TSQ icon for about 20 seconds allowing you to use the PTT button. If
\RXDUHQRWDEOHWRUHVSRQGZLWKLQWKHVHFRQGSHULRG764LFRQVWRSVÀDVKLQJDQG
‘QUIET’ mode resumes.
NOTE
The UH9060/UH9080 can decode a Selcall call even though not in
‘QUIET’ mode.
To Next Page
Loading...
Need help?
General
