39
UNIDEN UH9060/UH9080 UHF CB Transceiver
Operation - Special Features
Programming the Selcall ID
The radio Selcall ID is the ID other users will identify as being your radio. It is set in the
Selcall settings menu as follows:
1. Switch Off the Power.
2. Press and hold [POWER] and [MENU]. The UH9060/UH9080 should turn on in the
SELCALL Menu selection state (no tone will sound). Cd dispays to indicate the Call ID
setting (factory default ID is 00000).
3. Press [SCAN]WREHJLQWKH6HOFDOO,'HGLW7KHWKGLJLWRIWKH,'ÀDVKHV
4. Use
or to shift between digits. A 6th digit (for 6 tone Selcall) is available and
indicated by a ‘_’.
5. Press
/ to select the desired ID.
6. Press and hold [ENTER] to exit the setting mode.
7. Press and hold [ENTER] again to exit programming mode.
$ORQJFRQ¿UPDWLRQWRQHVRXQGV
Storing Selcall IDs of other users to the ID Memory
1. Press and hold [SELCALL]. The Selcall ID memory will open.
2. Press
/ to select the desired memory slot to edit.
NOTE
8SWR,'PHPRULHVFDQEHVWRUHG
,I\RXH[SHFWWRPDNHFDOOVWRUDGLRVQRWVWRUHGLQWKH,'PHPRU\WKHQ
leave memory ID 1 blank for manual ID entry at the time of the call.
3. Press [SCAN]WREHJLQWKH,'HGLW7KHWKGLJLWRIWKH,'ÀDVKHV
4. Use
or to shift between digits. A 6th digit (for 6 tone Selcall) is available and
indicated by a ‘_’.
5. Press
/ to select the desired ID.
6. When desired ID is entered press [SCAN] to move to Alpha Tag selection.
$FXUVRUÀDVKHVLQWKHVWDOSKDSRVLWLRQ7KHGHIDXOWDSOKDWDJLVEODQNGLVSOD\VDV
No Name. If you do not wish to name the ID then skip to step 9.
7. Press
/ to select the desired alpha character.
8. Use
or to shift between cursor positions.
:KHQ¿QLVKHGSUHVV[SCAN]$FRQ¿UPDWLRQWRQHVRXQGVWRLQGLFDWHWKH,'LV
SURJUDPPHG7KHPHPRU\QXPEHUÀDVKHVWRHQDEOHVHOHFWLRQIRUSURJUDPPLQJRI
next memory if desired.
10. Press and hold [ENTER], or wait for 10sec, to exit programming mode.
To Next Page
Loading...
Need help?
General
