Software Manual CWD 2005
___________________________________________________________________
46 Manual CWD2005.doc
Signal is a multiple choice scrolling list field with the following text entries:
Calorific Value; Wobbe, < Wobbe >, Specific Gravity, CV net <or gross>.
Type is a list field with the following entries: 0 20 mA or 4 20 mA
Calorific: BTU /ft
3
, kJ/Nm
3
, MJ/Nm
3
, kWh/Nm
3
, kcal/Nm
3
, kJ/Sm
3
, MJ/Sm
3
, kWh/Sm
3
kcal/Sm
3
Specific Gravity: specific to air (1.0), absolute kg/Nm
3
6.2.1.1.2. Relay output
The relay output configuration menu consists of signals in combination with threshold
values or operating status messages. If an alarm is triggered a message will appear
in the information field and the fault LED on the door will light.
Signal is a list field. Wobbe, Calorific Value and alarm messages can be selected.
Operation will show < > if an alarm value is programmed.
Unit and Value 1 and Value 2 fields contain configurable operating data.
Note: Zero position low = no power applied to relay coil in normal operation.
Zero position high = power applied to relay coil normal operation.
Eight normally open or normally closed contacts are available. (See section 10.2.1).
To Next Page
Loading...
