Software Manual CWD 2005
___________________________________________________________________
54 Manual CWD2005.doc
6.2.1.3.1. General
Change signal after hold provides in a soft transition to and from the calibration cycle
or when switching off the output signal hold module. This prevents a sudden rise or
fall in the measured value occurring in output signal. The transition between values is
shown in seconds and this allows the signals to blend together for a smooth transfer.
shutdown of the air fan following a shut down removes any residual heat from the
run
the cooling air fan continuously and the unit is ready for immediate use after a restart.
shown in seconds. In the example, the air fan will run for a further 30 seconds after
process gas shutdown before the fan shuts down automatically. (With a delayed
shutdown value of 0 the air fan to run continuously).
saver mode after a period of keypad inactivity.
constant response speed time. This value is preset at the
factory and varies from gas family to gas family and measuring ranges.
.
To Next Page
Loading...
