Unitech MS652 - Page 132

-115- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS652 User’s Manual
4.3.4 Control Character in Barcode
Scan below bar code to control character in barcode.
Send * Don’t Send
4.3.5 End of Batch Sending Message
Scan below bar code to set up end of batch sending message.
If ‘Send’ is selected, MS652 will send message “# End of File
Total=Number CS=0xHHHH #” before the end of batch file sending.
Number is total entries in decimal format and 0xHHHH is 32-bit checksum
in hex format.
Send
Don’t Send*