Unitech MS920 User Manual

128
Data decoding security - Center decoding - Activation - Enable
<SW>714101
•
••
•Tolerance
- The tolerance level for center decoding allows you to aim the laser close to
the bar code to be read rather than be positioned on the bar code.
- 0 = No tolerance (laser aimer must be positioned on the bar code to be read),
100 = most permissive (laser aimer can be positioned beside the bar code to
be read).
Data decoding security - Center decoding - Tolerance - No tolerance (*)
<SW>714200
•
••
•Bar code sequence
- Bar code sequence allows you to read up to 10 bar codes with one trigger
pull. This is useful when reading several bar codes placed closely together and
without re-reading the same code twice.
- For example, if set to 2, pull the trigger once and scan both codes. The
scanner beeps for each code that is decoded (2). If "turn off after good read" is
enabled the scanner turns off AFTER the last bar code in the sequence is
read.
- Compose the number of bar codes for the sequence.
Data decoding security - Bar code sequence - 1 (*)
<SW>714301

Unitech MS920 Specifications

General

Brand	Unitech
Model	MS920
Category	Scanner
Language	English