•
••
•Pre-defined trigger modes
- These are pre-defined trigger settings used to quickly set up your scanner.
- If you are using a pre-defined mode, do not set the other Scanning/triggering
settings.
One pull and release turns the aimer, illumination and decoding on. If no
decode, second pull and release turns the aimer, illumination and decoding off.
Pre-defined trigger modes - Toggle
<CCMD>405100
One pull turns on the aimer, illumination and decoding. If not decode, aimer,
illumination and decoding turn off when the trigger is released.
Pre-defined trigger modes - Level
<CCMD>405101
One pull turns on the aimer only. When the trigger is released, illumination and
decoding turn on. If no decode, second pull and release turn the aimer,
illumination and decoding off.
Pre-defined trigger modes - Aim
<CCMD>405102
•
••
•Scanning / Triggering
•
••
•Triggering modes
At power up the lighting and decoding are on all the time. The trigger is not
To Next Page
Loading...
