Unitech MS920

81
•
••
•check digit transmission
You can chose to transmit or not transmitted the check digit.
Code 39 - Check digit - check digit transmission - Disable (*)
<SW>425400
Code 39 - Check digit - check digit transmission - Enable
<SW>425401
•
••
•Barcode length
•
••
•Length mode
- L1 = Codes with as many characters as specified by L1 and longer are read
(L2 and L3 are not used).
- L2 = Only codes that comply with the lengths specified by L1, L2, and L3 will
be read.
- L3 = Codes at least the length specified by L1 and no longer than the
maximum length specified by L2 are read (L3 is not used).
Code 39 - Barcode length - Length mode - L1 as Minimal length (*)
<SW>425300
Code 39 - Barcode length - Length mode - L1, L2, L3 as fixed length
<SW>425301