Unitech MS920

46
(L2 and L3 are not used).
- L2 = Only codes that comply with the lengths specified by L1, L2, and L3 will
be read.
- L3 = Codes at least the length specified by L1 and no longer than the
maximum length specified by L2 are read (L3 is not used).
Plessey Code - Barcode length - Length mode - L1 as Minimal length (*)
<SW>475300
Plessey Code - Barcode length - Length mode - L1, L2, L3 as fixed length
<SW>475301
Plessey Code - Barcode length - Length mode - L1 as min, L2 as max
<SW>475302
•
••
•Set length L1, L2 and L3
•
••
•Postnet
Postnet - Disable (*)
<SW>304000
Postnet - Enable