Unitech MS920

40
starts after the last bar code is read.
- Value is in milliseconds.
•
••
•Incomplete decode event
- When active an Incomplete decode event is sent by the host if the trigger is
deactivated until all codes in the Multicode are read.
Multicode - Incomplete decode event - Disable (*)
<SW>594300
Multicode - Incomplete decode event - Enable
<SW>594301
•
••
•PDF417
- Two-dimensional symbology.
- Alphanumeric full ASCII symbology - letter case defined.
PDF417 - Enable (*)
<SW>4C4001
PDF417 - Disable
<SW>4C4000
•
••
•Symbology identifier
•
••
•User defined
- User defined symbology identifier.
- See "Data transmission settings - symbology identifier - UDSI" to activate or
deactivate UDSI transmission.