•
••
•Code mark
- See "Data transmission settings - symbology identifier - Code mark" to
activate or deactivate Code mark transmission.
- Use the default value or compose your Code mark for this symbology (1
character).
Multicode - Symbology identifier - Code mark - Complete Multicode default " * "
(*)
<SW>59482A
Complete Multicode Compose
Multicode - Symbology identifier - Code mark - Incomplete Multicode default " *
" (*)
<SW>59492A
•
••
•Incomplete transmission
- When active an Incomplete Multicode is transmitted.
- If not active, Incomplete Multicodes are discarded.
Multicode - Incomplete transmission - Disable (*)
<SW>594200
Multicode - Incomplete transmission - Enable
<SW>594201
•
••
•Incomplete transmission timeout
- Select the timeout used when Incomplete transmission is active. The timeout
To Next Page
Loading...
