Unitech MS920

13
Event notification
- When active, the scanner notifies the host when certain events take place.
- Only available when data format is set to packet format.
- For information on the event frames that the host will receive from the
scanner see the ISCP online help available in the help menu in Easyset.
•
••
•ISCP bar code
- When active the scanner informs the host of the following information after
reading and processing an ISCP bar code:
- Error (if any)
- Type of ISCP bar code (setup, status, etc.)
- GID
- FID
- Parameter
- For information on the event frame received by the host see the ISCP online
help available in the help menu in Easyset.
ISCP - Event notification - ISCP bar code - Enable (*)
<SW>734301
ISCP - Event notification - ISCP bar code - Disable
<SW>734300
•
••
•Preprocessing ISCP bar code
- When active the scanner informs the host of the following information after
reading but BEFORE processing an ISCP bar code:
- GID
- FID
- Parameter
- For information on the event frame received by the host see the ISCP online
help available in the help menu in Easyset.
ISCP - Event notification - Preprocessing ISCP bar code - Disable (*)
<SW>734400